*The products produced by Galvanized Manual Roofing Ridge Cap Cold roll forming machine are bright in colored, against fading, resistant to rust, and be widely used in shops, working departments, warehouses, and fire partition. Its strength is three times higher than aluminum alloy door.
*Function and feature
This Galvanized Manual Roofing Ridge Cap Cold roll forming machine uses galvanized steel sheet, colored armor plate or aluminum plate as the material plate.
|No.||Item||Galvanized Manual Roofing Ridge Cap Cold roll forming machine|
|3.||Coil width||According to the sample|
|4.||Material of Rollers||45# steel, with hard chrome coated|
|5.||Diameter of Shaft||40mm|
|7.||Roller Driven||Decelerating Motor+Chain Transmission|
|8.||Cutting Model||Hydraulic Profile Cutting|
|11.||Operation Model||Button + Touch Screen|
|13.||Voltage||380V 50HZ or at buyer's request|
*Galvanized Manual Roofing Ridge Cap Cold roll forming machine consists of Manual Uncoiler , Feeding Table , Main roll forming machine , Hydraulic System , Shearing Mechanism , Computer Control Cabinet .
Usage: It is used to support the steel coil and uncoil it The steel coil is expansion by hand.
Inner diameter: 450-508mm
Put the raw material (steel plate) through the beach to manufacture and process, it can guarantee that the products are neat, parallel and everything is uniformity. Please refer to the equipment regulation to know the function of locate angle iron.
3. Main roll forming machine:
It is designed according to the customers’ profile drawing. It adopts motor reducer drive, chain transmission, roller surfaces polishing, hard plating, heat treatment and galvanization treatment. The polished surface and the heat treatment towards the molds also can keep the molding plate surface smooth and not easy to be marked when it is being stamped.
Adjusting every parts in good condition then ship
Material of rollers: 45# steel, surface hard chromium plating.
Main power: 3kw(cycloidal planetary gear speed reducer)
Galvanized Manual Roofing Ridge Cap Cold roll forming machine
3.Computer Control Cabinet:
It adopts Delta/Siemens PLC to control. The target piece’s length is adjustable and digit of it can be adjusted. Computed mode has two modes: automatic and manual one. The system is easy to operate and use.
It adopts the hydraulic drive and automatic location to decide the dimension and cut the target products. Material of blades: Cr12
Components: It contains one set of cutting tools, one hydraulic tank and one cutter machine. Design the knives according the formed sheet
It is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank, the pump drives the cutter machine to begin the cutting job. Power:3kw
Hydraulic oil: 40#
Components: The system includes a set of hydraulic tank, a set of hydraulic oil pump, and two hydraulic pipes. And two sets of electromagnetism valves. With reducer combination, long life, high precision